IEC 62722-1-2014 pdf download.Luminaire performance – Part 1: General requirements.
This part of IEC 62722 covers specific performance and environmental requirements for luminaires, incorporating electric light sources for operation from supply voltages up to 1 000 V. Unless otherwise detailed, performance data covered under the scope of this standard are for the luminaires in a condition representative of new manufacture, with any specified initial aging procedures completed. IEC 62722-1 covers requirements for luminaires to support energy efficient use and responsible environmental management to the end of life. The object of this Part 1 is to provide a set of requirements which are considered to be generally applicable to most types of luminaires.
Where additional performance requirements for specific types of light source are relevant, these are specified in the IEC 62722-2 series. The IEC 62722-2 series may also cover a wider scope of performance aspects appropriate to the particular light source technology. NOTE The structure of these performance standards also allows for the possibility of Part 3 standards to be introduced in the future should standardisation of performance criteria linked to specific luminaire applications be determined as necessary (e.g. floodlighting, street lighting, etc.). It is the intention that the requirements of this Part 1 are to be met by the provision of information and data provided by the luminaire manufacturer (or responsible vendor). Conformity is considered to be met by the provision of the requested information. Any verification of data is to be conducted by the measurement requirements of this standard. Semi-luminaires are not covered under the scope of this standard. For some types of luminaire (e.g. decorative/household) the provision of performance data under the scope of this standard may not be appropriate.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
IEC 60598-1 , Luminaires – Part 1: General requirements and tests
IEC 60598-2 (all parts), Luminaires – Part 2: Particular requirements
IEC 60598-2-22, Luminaires – Part 2-22: Particular requirements – Luminaires for emergency lighting
IEC 62722-2 (all parts), Luminaire performance – Part 2: Particular requirements CIE 34:1 977, Road lighting lantern and installation data: Photometrics, classification and performance
CIE 43:1 979, Photometry of floodlights
CIE 1 21 :1 996, The photometry and goniophotometry of luminaires
CIE 1 21 -SP1 :2009, The photometry and goniophotometry of luminaires – Supplement 1:
Luminaires for emergency lighting
NOTE Annex A provides details of regional standards the use of which are preferred in some countries.
3 Terms and definitions
For the purposes of this document, the terms and definitions given in the IEC 60598-1 as well as the following apply.
3.1 input power
electrical power from the mains supply consumed by the luminaire including the operation of all electrical components necessary for its intended functioning
3.2 standby power
electrical power from the mains supply consumed by the luminaire under normal operating conditions, with the lamps switched off via a control signal
Note 1 to entry: Standby power is expressed in watts.
Note 2 to entry: For emergency lighting luminaires this does not include the emergency lighting charging power.
3.3 emergency lighting charging power
electrical power from the mains supply consumed by the charging circuit of emergency luminaires to keep the battery charged
Note 1 to entry: Emergency lighting charging power is expressed in watts.
3.4 luminaire efficacy
ratio of the luminaires total luminous flux versus its input power at rated supply voltage, excluding any emergency lighting charging power.IEC 62722-1 pdf download.