IEC 62341-6-2-2015 pdf download.Organic light emitting diode (OLED) displays – Part 2-1: Essential ratings and characteristics of OLED display modules.
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
Void.
3 Organic light emitting diode (OLED) display modules
3.1 Types of OLED display modules
The OLED display modules include the following types:
– passive matrix monochrome OLED display modules,
– passive matrix colour OLED display modules,
– active matrix colour OLED display modules.
3.2 Principles and structure
The OLED display modules consist of OLED display panels, electronic circuits, and usually
bezels.
EXAMPLE A thin film transistor (TFT) (polycrystalline silicon, oxide, organic materials) active matrix display cell
with electronic circuits and connector pins.
3.3 Modes of operation
3.3.1 Addressing mode of operation
The addressing mode of operation for OLED display modules includes the following types:
– passive matrix,
– active matrix, etc.
3.3.2 Optical mode of operation
The addressing mode of operation for OLED display modules includes the following types:
– illumination mode: for example top-emission, bottom-emission,
– number of colours,
– number of grey scales.
3.4 Details of outline
3.4.1 Material and mechanical description
The material and mechanical description of OLED display modules is as follows:
– substrate material: for examples glass, plastic, etc.,
– bezel material: for example plastic, metal, etc.
3.4.2 Connection types
The connection types of OLED display modules are as follows:
– connector,
– flex cable,
– connection pins, etc.
3.4.3 Outline drawing and dimensions
The outline drawing and dimensions of OLED display modules are as follows:
– overall dimensions,
– bezel dimensions,
– active display area and display centre.
3.5 Limiting values (absolute maximum rating system) over the operating temperature range, unless otherwise stated
The following limiting values should be specified in Table 1 .
3.6 Electrical and optical characteristics
The following characteristics should be specified in Table 2.
3.7 Supplementary information
3.7.1 Timing characteristics, timing of logic voltages and data/format interface specification.
3.7.2 Supply voltages sequence condition, where appropriate.
3.7.3 Operating voltage range, if appropriate, as a function of temperature at specified contrast ratio.
3.7.4 Handing and operating information.
3.7.5 Precautions with respect to electrostatic discharges.
3.7.6 Precautions of installation: mechanical and/or electrical.
3.7.7 Safety information.
3.7.8 Characterization of diffuse and specular reflectance and transmittance.IEC 62341-6-2 pdf download.